DeVilbiss FLG-P5-14 User Manual download pdf (Page 2)

ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.

Operation Manual

FLG5 – Pressure-Feed Spray Gun

Important

Read and follow all instructions and Safety warnings before using this

equipment

Description

The FLG5 pressure feed Spraygun is fitted with a 1.4mm Nozzle for use with common

coating materials. A 1.1mm Nozzle and Needle is available as an alternative. The

FLG5 Spraygun is approved to ATEX regulations 94/9/EC, protection level;

II 2 G X. Suitable for use in Zones 1 and 2

Important: These spray guns are suitable for use with both water-based and solvent-

based coating materials. The design uses EPA compliant atomising (Devilbiss Trans-

Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and

needles are manufactured in stainless steel. These guns are not designed for use with

highly corrosive and/or abrasive materials and if used with such materials it must be

expected that the need for cleaning and/or replacement of parts will be increased. If

there is any doubt regarding the suitability of a specific material contact your local

Distributor or ITW Finishing direct.

SPECIFICATION

Air supply connection – Universal

BSP and NPS

Maximum static air inlet pressure – P

= 12 bar (175 psi)

Nominal gun inlet pressure with gun triggered – 2.4 bar (35 psi)

Maximum Service temperature – 40°C

Gun Weight – 930g

Airflow – 277 l/min (9.8 cfm)

Materials of Construction

Gun body – Aluminium. Stainless steel fluid passages

Nozzle – Stainless steel

Needle – Stainless Steel

1 2 3 4 5 6 7 ... 31 32

No comments

DeVilbiss FLG-P5-14 User Manual Page 2